TerraSlave: failed to load block points

Problem:  Attempting to run a macro through TerraSlave results in the following message in the TerraSlave Processing Report: “Failed to load block points”   Solution: This can be caused by an incompatibility between the software and the point cloud format. For example, attempting to process LAS 1.4 data using the 32-bit TerraSlave. In this case,…

Share

TerraSlave: No active task

Problem: When attempting to run a macro on a project using TerraSlave and the following message is reported in TerraSlave’s Monitor Active Task dialog, try the following steps: Probable Resolution#1: In your Terra installation folder, open your TSlave folder. Then clear the contents from the following folders: ‘progress’, ‘queue’, and ‘task’. Probable Resolution#2: Ensure that…

Share

Trajectories for Run Macro Step

Problem: When running a macro through TerraSlave from GeoCue, routines that depend upon trajectory information can fail to return any results.  These routines include “Cut Overlap-Cut by Offset option” and “Apply Corrections”. Cause: When assigning and running a macro through TerraSlave from GeoCue, there is no setting to select which trajectory layer to use as…

Share