Repair Tools for GeoCue Entities and Layers

The Repair command is an administrative level tool used for facilitating changes to project entities. The repair tools are accessed through the Setup pull-down menu under Administration (GeoCue Client -> Setup -> Administration -> Repair Tools ). The Status Changer has the ability to change system integrity properties of entities (e.g. locks). 1. Select the…

Share

Horizontal Accuracy Reporting in LP360

In November 2014, the American Society for Photogrammetry and Remote Sensing (ASPRS) released an updated standard, Positional Accuracy Standards for Digital Geospatial Data, to tie together past experience with current industry practice of preparing data, but not plotting the resulting maps. The new standard provides guidelines for calculating both the vertical and the horizontal accuracy.…

Share

LP360 Control Points

In configuring a set of control points or check points for use in the LP360 Control Points Toolbar it is best to follow the convention below to make the most use of the Drive Mode shortcuts available within the toolbar for navigation and filtering. The fields either need to exist in the shapefile or may…

Share