The third part in the training series for our True View 3DIS (3D Imaging Systems) is an introduction to the True View 3DIS flight planning. This is a continuation from True View 3DIS Training Part 2: Hardware Installation and Setup.
Start – Basics of planning a True View LiDAR Mission
03:50 – Flying height
07:50 – Scan angle
13:15 – Flight line widths
19:58 – Helpful formulas, flight planning spread sheet (available in your Reckon account under Downloads -> Notices), flight planning parameters,
35:28 – Useful flight default settings – for different terrains / mission purposes.
Training continues with the True View 3DIS Training Part 4: Flight Planning continued.
