This article covers two accessory kits compatible with TrueView GO 116S and TrueView GO 132S:
– Extension Pole Kit
– Car Mount Tripod Adapter Kit or suction cup car mount kit
Extension Pole Kit
What’s included:
– 2.5 m telescopic extension pole
– Mounting bracket
– Loctite thread locker (for mounting hardware)
2.5 m telescopic pole
– The pole has a 5/8″-11 threaded attachment at the end.
– You can mount the TVGO directly onto the pole by removing (unscrewing) the TVGO handle and attaching the unit to the pole’s 5/8″-11 thread.
– This setup is intended to help you reach higher locations (for example: roofs).
Mounting bracket
The purpose of the bracket is to keep the TrueView GO scanner upright when the scanner is positioned below you on the pole.
– Use the mounting bracket in cases where you need to scan areas below your position, such as:
– Inside a silo
– Down the side of a bridge
Installation:
– The mounting bracket should fit on the black portion of the extension pole (32 mm diameter).
– Thread locker (important): Use the provided Loctite thread locker between the 1/4-20 screw and the 5/8″-11 adapter when mounting the TrueView GO.
Car Mount Tripod Adapter Kit
What’s included:
– Car mount tripod (suction cup mount)
– 1/4″-20 to 5/8″-11 adapter
– 10 cm extension rod (may be black or yellow)
Installation:
– The car mount tripod installs using suction cups onto the hood or another suitable part of the vehicle.
– The 1/4″-20 to 5/8″-11 adapter allows mounting of the 10 cm extension rod to the tripod.
– To ensure a safe mount, apply the provided thread locker to the 1/4″-20 screw threads.
– The 10 cm rod goes between the tripod mount and the TrueView GO. It provides clearance from the surface to help avoid interference.
