Elevation error troubleshooting

There are several reasons that a point cloud or ortho data may not align with checkpoints to the expected accuracy. Below is a list of common reasons that this might occur. Base station position In PPK processing, the base station position, antenna height and antenna calibration file must be correct. Please review the Base Station…

Share

RTK Flight Type in ASPSuite

With the release of ASPSuite version 2019.1, RTK mode has been added as a Flight Type on the New Project/ Flight Wizard. This new tool was developed to allow Phantom 4 RTK users, who’s images have been corrected by the D-RTK 2 base station or VRS, to convert image heights from ellipsoid to orthometric height…

Share

How do I switch the language being used by ASPSuite?

ASPSuite by default will launch in English, unless it’s running on an operating system that is a supported language. With the release of v2019.1, the supported languages in ASPSuite are French, German, Spanish, and Japanese. To modify the language on start up: Holding “CTRL+ ‘e’” while clicking on the icon to launch the program will…

Share

What’s New in Terrasolid – Feb 2019

The following are the highlights of the new features that have been added to the Terrasolid software between February 2018 and February 2019, and can be found in the version 019 releases. Works in Map PowerView CONNECT Edition Various Improvements Support for reading Leica PTS file format Parameter, Dimension, Normal X, Normal Y and Normal…

Share

TerraScan Supported Point File Formats

TerraScan has built-in support for the following laser point file formats: T = text file format R = read files B = binary file format W = write files Name: Type: Content: FASTBINARY B R/W TerraScan Fast binary (FBI). SCAN8 B R/W TerraScan binary with 8 bit flightline numbers (BIN). SCAN16 B R/W TerraScan binary…

Share

Checking the Number of Valid Satellites Used by ASPSuite.

ASPSuite has the ability to filter out GNSS satellites based on elevation mask, and Signal-to-noise ratio (SNR) mask. Before reprocessing with increased mask settings, it is good practice to check the number of valid satellites used in the solution. The following steps describe the process for checking the number of valid satellites used in the…

Share

TerraScan Error: Cannot save file

Problem: Attempting to save points as in TerraScan results in an error stating, “Cannot save file”. Probable Resolution: The error message usually results when the operating system throws an error when TerraScan is attempting to save the file. It can happen if: the drive is out of space the file is open for read or…

Share

Terrasolid Product Installation & Setup Guide

This guide provides information on how to install, register and configure your Terrasolid products and licenses. Installing TerraSolid Products Guide v019 Contents Introduction…………………………………………………………………………………………………………… 1 Invoice……………………………………………………………………………………………………………….. 1 About Terrasolid OY…………………………………………………………………………………………………….. 1 About GeoCue Group……………………………………………………………………………………………………… 1 Downloading the Installation Packages…………………………………………………………………………………….. 2 Bentley MicroStation Based Packages……………………………………………………………………………… 2 Microsoft Windows Based Packages……………………………………………………………………………….. 4 Installing the Products………………………………………………………………………………………………….. 5 Registering Your…

Share

Metashape: Failed to Build Orthomosaic

Problem: When processing in Agisoft’s Metashape or PhotoScan, the Build Orthomosaic step fails. The details may contain a message, “Error: Can’t write file: There is not enough space on the disk (112). Probable Resolution #1: Check the disk space to ensure there is sufficient space to complete the task. If not, remove unnecessary files and try building the…

Share