GeoCue Support » Drone, Mobile and Handheld Mapping » TrueView Tools, Tips and Workflows » Page 15
This page is no longer updated. Please visit the updated page on the new LP360 Support Knowledge Base for the latest information. LP360 Drone, formerly TrueView Evo, doesn’t recognize Cycle Folder. This can happen when attempting to load directly from the UMS drive or from an archive folder. The Cycle dialog will not show flight…
A walk through of the True View 410 post-flight operations procedure. Refer to the True View 410 Hardware Users Guide for more information.
A demonstration of the True View Heading Alignment Maneuver for models with a LIDAR unit. Refer to the True View 410 Hardware Users Guide for more information.
A walk through of the True View 410 pre-flight operations procedure. Refer to the True View 410 Hardware Users Guide for more information.
Phantom 4 processing with ASPSuite has been superseded by LP360 Drone. The DJI Phantom 4 RTK can be flown and processed with both Real Time Kinematic (RTK) and Post Processed Kinematic (PPK) workflows in mind. The video shows the step-by-step process of using a DJI Phantom 4 RTK from flight planning to ASPSuite processing.
Applies to TrueView vA firmware v2.0.4 through v4.0.0 Once a flight mission is complete and the aircraft returns to the home position the Wind Down process will initiate due to the proximity mode. Proximity mode allows the Wind Down process to take less time to write the image files to the external UMS stick once…
Frequently asked questions about our sUAS based drone mapping solutions, including our Loki system.
When using Loki with the Inspire 2 Personality cable, DSLR cable, or direct hardwire camera cable, the number of external events recorded can be confirmed by opening the sbf.blocks.txt file in the PPK folder in the ASPSuite project folder (root folder). There should be a block (highlighted in the image above) that begins with “#…
In ASPSuite, RTKPlot is not opening and the user observes an error message about “Text.Lines.Strings”, “RichEdit” and a number of Non-English characters. Microsoft Office installation can cause this function to not run properly. Reinstall Microsoft Office Suite.
Attempting to run POSPacCloud to process the trajectory solution for a True View 410 results in an error message stating, “POSBAT_PARSE_FAILED”. POSPacCloud has a limitation in that not only can it not handle accented characters in the path, but it also cannot handle the regional settings where a comma is used instead of a decimal.…