Manually Install TerraSlaveService

The TerraSlaveService is required in order to use a machine as a slave machine for the TerraDispatcher. If the TerraSlaveService does not install as it should using the setup.exe, manually install the service. Open an elevated command prompt by right-clicking on Command Prompt in the Start menu and selecting “Run as Administrator”. Type “sc create…

Share

TerraSlave: No active task

Problem: When attempting to run a macro on a project using TerraSlave and the following message is reported in TerraSlave’s Monitor Active Task dialog, try the following steps: Probable Resolution#1: In your Terra installation folder, open your TSlave folder. Then clear the contents from the following folders: ‘progress’, ‘queue’, and ‘task’. Probable Resolution#2: Ensure that…

Share

Trajectories for Run Macro Step

Problem: When running a macro through TerraSlave from GeoCue, routines that depend upon trajectory information can fail to return any results.  These routines include “Cut Overlap-Cut by Offset option” and “Apply Corrections”. Cause: When assigning and running a macro through TerraSlave from GeoCue, there is no setting to select which trajectory layer to use as…

Share