GeoCue Support » You searched for loki
…version installed on your Loki by following steps 1-5 above. The current Loki firmware version is v1.8.2. If your version is older, provide the installed Loki firmware version, the Loki…
The Loki Users Guide – DJI (updated 7/24/19) will guide you through assembly, installation, and how to use the Loki in conjunction with DJI Inspire 2, Phantom 4 Pro, and…
…has been turned on, as opposed to depending solely on the battery LED. The Loki is charged using a USB type C cable included with every Loki that is shipped….
There is an option in the ASP Suite Loki update dialog to turn on/off wide-band interference mitigation of the Septentrio. Below are screenshots showing how to change these settings. Please…
The answer to this question will depend on the Structure from Motion software being used. The two primary components are: The ability to use high-accuracy geotags. Loki provides highly accurate…
Problem: To use the SBF file (Loki file), ASPSuite will convert it into Rinex observation and navigation files during the file conversion step (Step 2). If the SBF file has…
…problem, try taking the Loki off the drone and screw the antenna directly on to the Loki. Then, place the Loki in an area with a clear view of the…
…reconnected to USB power. We recommend fully charging Loki no more than one day in advance of flight. More information about battery life can be found here: https://support.geocue.com/loki-battery-life-information/?highlight=loki%20battery%20life …
SBF stands for Septentrio Binary Format and the SBF file contains the GPS position as recorded by Loki. Loki receives its time from GPS satellites and therefore, the time associated…
Watch the video for instructions on how to install Loki on your Inspire 2. How to Install Loki on an Inspire 2 Drone from GeoCue Group on Vimeo….
