memory

Array dimensions exceeded supported range

Posted on by GeoCue Support

Attempting to populate LAS Working Segments in GeoCue results in an exception message in the system message column of the checklist step details pane for the Populate step stating, “System.OutOfMemoryException: Array dimensions exceeded supported range.    at NIIRS10.LASLib.LASStructArray6..ctor(Int32 size, Int32 numExtraBytes, Byte formatOnDisk) in N:\GeoCue 2017.1\iDEMS\iDEMSShared\LASLib\LASstructures.cs:line 2844    at NIIRS10.LASLib.LAS.AllocatePointDataRecordArray(LAS las, Int32 size) in N:\GeoCue…

Share

LP360: Out of Memory in CPointCacheManager

Posted on by GeoCue Support

While using LP360 the user receives the error message, “Out of Memory in CPointCacheManager”. The error message indicates that the system was unable to allocate the additional memory requested by LP360. If this occurs while drawing a long or wide profile, follow the instructions in the error message, “reduce the size of the Profile and…

Share

Memory Error When Building Mesh in PhotoScan

Posted on by AirGon Support

One of the steps in AirGon’s PhotoScan processing workflow is to build a 3D mesh.  The mesh building step usually consumes more memory than other steps in the workflow and can lead to a memory error if the capacity is exceeded.  The source of this problem can sometimes be traced back to the selection of…

Share

Did you know that you can “tune” how LP360 uses memory?

Posted on by Lewis Graham

Did you know that you can “tune” how LP360 uses memory? This is accomplished via the Performance tab on the LAS Layer Properties dialog (Figure 1). A word of caution is in order before modifying these settings. If you are running a 32-bit version of LP360 (and, unfortunately, LP360 for ArcGIS® is forced to be…

Share